3com parallel tasking 2 driver windows 7

Publish Power BI to non-licensed users Software.If this gets too messy I will draw up a Viso doc and post that for clarification.Ĭan someone offer a routing newbie some advice or good reading material? I saw a lot of complaints about 3Com documentation while searching for an answer. Nothing like adding a few wrinkles to the mix, eh? We also have a new E10 service installed from a local ISP which allows me to test in parallel environment. The new one I want am configuring in Routed Mode. Right now the old unit is configured in 'Drop In Mode' where all interfaces have the same addresses. Where is all get confusing for me is that I'm also upgrading our Watchguard Firewall. From here I just try pinging each gateway and machine.

I've have assigned Port 2 untagged to the newly created (after first adding the routes) VLAN 2 on the switch. To test this I have a 2 machines configured with 1.x and 2.x addresses and gateways plugged into Port 1 and Port 2. In Googling I found a reference to turning off Spanning Tree Protocol so I have done this. In the new 3CR17450-91 you have to assign a gateway and metric to each route. The old switch has this routing statement:ĭestination Subnetmask Metric Gateway Status I'm trying to copy the old config but the inferface seems a little different in its options.

Its replacing an older model we have in service. I need some help on configuring routing between VLANs on a new 3Com 3870 switch.

3com parallel tasking 2 driver windows 7